|
Tools
needed
Only a few tools are required for installation.
Fined-toothed saw, tape measure,try square, hammer, wood
blocks, etc.
|
（一） |
Underlay
To improve sound
insulation and enhance walking comfort, it is recommended
to put a foam underlay. |
（二）
|
Start installation from one room corner,
grooved edge to the wall.with wood spacers between the
board and wall (usually 10~15mm to prevent deformation). |
（三）
|
| After
complete the first row, the offcuts should be used to
begin the next row. |
（四）
|
| Beginning
from the second row, apply enough jointing glue to the
groove. |
（五）
|
| To
joint the floor board together, beat slightly through
the wood blocks, and any excess of glue should be wiped
off immediately. |
（六）
|
|
Attention
- After installation
it is strongly recommended to leave the floor unused for
24 hours, so as to allow enough time for glue to set.
- Never forget
to remove the wood spacers after installment.
- Never use
excessive water in cleaning. Daily cleaning shall be done
by a vacuum cleaner or a damp cloth.
|
|
|
